255mm
K-Tech shock absorber springs are manufactured from the highest-quality chrome-silicon wire; each spring is cold-wound, heat-treated, pre-set, and ground to length. A phosphate coating is then applied to protect against corrosion, followed by powder coating, before the part number is applied. All springs are manufactured in accordance with DIN 2095 Class 1.
- Cold-wound
- Heat-treated
- Hardened
- Shot-blasted
- Ground ends
- Zinc-phosphated
- Epoxy powder-coated
- Part numbered
K-Tech shock absorber springs are manufactured from the highest-quality chrome-silicon wire; each spring is cold-wound, heat-treated, pre-set, and ground to length. A phosphate coating is then applied to protect against corrosion, followed by powder coating, before the part number is applied. All springs are manufactured in accordance with DIN 2095 Class 1.
- Cold-wound
- Heat-treated
- Hardened
- Shot-blasted
- Ground ends
- Zinc-phosphated
- Epoxy powder-coated
- Part numbered
K-Tech shock absorber springs are manufactured from the highest-quality chrome-silicon wire; each spring is cold-wound, heat-treated, pre-set, and ground to length. A phosphate coating is then applied to protect against corrosion, followed by powder coating, before the part number is applied. All springs are manufactured in accordance with DIN 2095 Class 1.
- Cold-wound
- Heat-treated
- Hardened
- Shot-blasted
- Ground ends
- Zinc-phosphated
- Epoxy powder-coated
- Part numbered
K-Tech shock absorber springs are manufactured from the highest-quality chrome-silicon wire; each spring is cold-wound, heat-treated, pre-set, and ground to length. A phosphate coating is then applied to protect against corrosion, followed by powder coating, before the part number is applied. All springs are manufactured in accordance with DIN 2095 Class 1.
- Cold-wound
- Heat-treated
- Hardened
- Shot-blasted
- Ground ends
- Zinc-phosphated
- Epoxy powder-coated
- Part numbered
K-Tech shock absorber springs are manufactured from the highest-quality chrome-silicon wire; each spring is cold-wound, heat-treated, pre-set, and ground to length. A phosphate coating is then applied to protect against corrosion, followed by powder coating, before the part number is applied. All springs are manufactured in accordance with DIN 2095 Class 1.
- Cold-wound
- Heat-treated
- Hardened
- Shot-blasted
- Ground ends
- Zinc-phosphated
- Epoxy powder-coated
- Part numbered
K-Tech shock absorber springs are manufactured from the highest-quality chrome-silicon wire; each spring is cold-wound, heat-treated, pre-set, and ground to length. A phosphate coating is then applied to protect against corrosion, followed by powder coating, before the part number is applied. All springs are manufactured in accordance with DIN 2095 Class 1.
- Cold-wound
- Heat-treated
- Hardened
- Shot-blasted
- Ground ends
- Zinc-phosphated
- Epoxy powder-coated
- Part numbered
KX 85 (00-15)
KX 85 (2000–2015)
KX 85 (00-15)
KX 85 (2000–2015)
